Engineering Specifications for Applying SportMaster
Color Coating Systems over asphalt tennis court surfaces
Form CMT-24
1. SCOPE
1.1 The following specifications pertain to the
application of SportMaster Color Coating Systems over asphalt tennis
court surfaces. Refer to Product Technical Data sheets for specific
mixing and application instructions.
2. SURFACE PREPARATION
2.1 New asphalt surfaces must cure 30 days prior to
application. The surface must be cleaned entirely of dust, dirt, debris,
and all loose materials.
2.2 Fill all cracks with SportMaster Crack Magic,
Acrylic Crack Patch, or other suitable crack filler.
2.3 Level depressions or "bird baths" (1/8
inch or deeper) with SportMaster Acrylic Patch Binder or Acrylic
Resurfacer patching mix.
2.4 Apply one or two coats of SportMaster Acrylic
Resurfacer as required by surface roughness and porosity to provide a
smooth underlayment for application of the SportMaster Color System.
3. APPLICATION OF SPORTMASTER COLOR SYSTEM
3.1 Over properly prepared asphalt surface apply a
minimum of two coats of SportMaster Color Concentrate in accordance with
manufacturer's mixing and application instructions.
4. LINE MARKINGS
4.1 Line markings shall be laid out according to
United States Tennis Association specifications.
4.2 After masking tape has been laid apply SportMaster
Stripe Rite line primer to seal voids between masking tape and court
surface to prevent "bleed under" when SportMaster Line Paint
is applied.
4.3 Apply a minimum of one coat of SportMaster Line
Paint.
5. GENERAL
5.1 All work shall be performed in a workmanlike
manner. All containers and debris shall be removed from job when
completed.
WARRANTY
The statements made on this technical bulletin are
believed to be true and accurate, and are intended to provide a guide
for approved construction practices. SealMaster?does not make, nor does
it authorize any agent or representative to make any warranty, express
or implied, concerning this material as workmanship, weather,
construction, equipment utilized and other variables affecting results
are all beyond our control. SealMaster?warrants only that the material
conforms too products specifications and any liability to the buyer or
use of this product is limited to the replacement value of the product
only. In no event shall SealMaster?be liable for any injury, loss or
damage, either direct or incidental, special or consequential, however
arising, in connection with material or equipment furnished or work
performed. SealMaster?shall not, in any manner, be liable for any
defects, variations or change in condition in the substructure over
which its products are installed.
Back
Top
¡@